K
Size: a a a
2020 June 04
VG
How to reload settings when changing mtu inside [ppp] without kicking out users? accel-cmd reload didnt work
it should be reloadable, how did you figure it's not?
S
Analberto Rodrigues
hi guys, i'm trying to implement ipv4 / ipv6 on shared vlan, pppoe on vlan 900 and ipoe on vlan 889, pppoe is working ipv4 / ipv6, but cpe on ipoe does not get ipv6, this is my configuration, am I missing something?
what do you expect? I've checked your dump. There are no dhcpv6 requests from CPE
Z
it should be reloadable, how did you figure it's not?
I checked the newly connected users after my commit and mtu didnt change (saw in ifconfig). Note i am changing max-mtu value
VG
mtu gets negotiated, based on server defaults, min/max values and client ones. so, lcp log is necessary
VG
plus accel-ppp config [ppp] and [proto] sections
AR
smth = something ?
AR
ok 😊
AR
i already tried 5 cpe models, but ipv6 solict is not coming when in ipoe, i will try to find out if it is some block, thank you all
AC
Hi
AC
what is the correct way to use the following parameters:
AC
lcp-echo-interval=n
lcp-echo-failure=n
lcp-echo-timeout=sec
AC
I know that two are used together and one is used individually...
AC
as far as i could imagine, one should use
lcp-echo-timeout individually, but in doing so, some pppoe session, which the subscriber has, for example, turned off the CPE, remains active forever...