This is mostly based on my Rasptop from  https://www.thingiverse.com/thing:2804933
It uses the same palmrest screws, keyboard, speakers, hinge screws, and USB panel mounts as the Rasptop above but with a better screen and more versatility.
A note on screen choices!
The Official Raspberry Pi Foundation Touchscreen has a resolution of 800x480 and is the easiest to wire but it's expensive to buy and that resolution is TERRIBLE for day to day use. You can force it to a better resolution on a Raspberry Pi by using the config.txt and setting the framebuffer size higher.
Set as follows:
framebuffer_width=1024
framebuffer_height=614
That helps a lot, but it's a hack.
There's many HDMI screens of better resolution out there and that's why I made the 2.0 here. I used a 1024x800 HDMI 7" 10 point touchscreen listed in the BOM. These are commonly USB powered and use USB for the touchscreen too. Both windows and linu supports it out of the box. Super easy!
Now, I have found that I needed to tweak the config.txt for these…