In today's video, I unbox, setup, and run lots of tests on the new E3D Hemera (formerly Hermes).  Through these detailed tests, I let you know if this is the extruder to end all extruders.

Purchase (some are affiliate links):
Hemera: http://bit.ly/35IfkaE
Hemera UK: http://bit.ly/37NoB2l
Ninjaflex: https://amzn.to/2RBj0E2
Cheetah: https://amzn.to/2FvQsFW
Fiberflex 30D: http://bit.ly/2SJR1Ua
nGen: https://amzn.to/2HyW3Rv
Nylon X: http://bit.ly/2nIzu0o
Filamentech CFPLA: http://bit.ly/2TfjK6f
Polylite PLA: http://bit.ly/3247YMG
Cable management: https://amzn.to/2FycxGg
3D Printing Failures book: https://amzn.to/2pQGOfc

Since I was asked, these were my settings during my first Ninjaflex test: http://bit.ly/2FCalNW
My retraction settings may have been too high for this extruder, so you may want to lower those numbers to help reduce those pesky clogs.  

My video detailing extruders: https://www.youtube.com/watch?v=64jnJdbeIjQ

Design Files Used:
Hemera Mount for CR-10 Type Printers: https://www.myminifactory.com/object/3d…