NOTE: this is a reversed mount, the hotend fan faces RIGHT, not left. I chose this mainly as it places more weight closer to the M5s and it puts the Nozzle a lot closer to its original position on V6/OEM mounts. Meaning less confusion about offsets etc.
Here is my 6-8 month build of a hemera mount
Listed the whole thing as a remix as I copied the slots on the cooling wings
Base Parts Needed, 4 M3x5 and some 4*M3x15 for the fans and 4 similar for an endstop
Printed: 1 of each except 2 M5 washers (also provided)
More M3x5 for the probe mount, and the dual fan spacer is any M3s longer than 12mm
Overall print instructions are
Layer height 0.2mm
No supports, print BP7 (baseplate) upside down and two M5 washers (for the top two M5s)
Use the washers on the top two m5 screws (screw-head) side and DO NOT screw the baseplate onto the gantry yet
Place and hold in 3 M5 nylock (or normal) Nuts into the baseplate
You must use 4 M3x5 screws to screw the back of the baseplate onto the hemera, use a cross screw pattern.
Then…